Quick navigation: PRODUCTS > ACCESSORIES

RST 029 - Set-Up Table according to DIN EN 55016-1-4 Rack and tabletop are made of a synthetic foam with low permittivity, therefore field strength measurements are much less effected by this table compared with an ordinary wooden table. For that reason the standard uncertainty, measured in decibel, is much lower and the clearance to the defined limit value line can be reduced. Developed in co-operation with the german authority "Bundesnetzagentur". Description: (124 kB) Available designs: RST 029-40 Load capacity ca. 40 kg RST 029-100   Load capacity ca. 100 kg Fibre-optic These fibre-optic cables, transmitters and receivers are harmonized together. Only togeter the enable the control of all our motion devices over a distance of up to 80 metre (50 metre with the older round Amphenol plug). With a repeater the distance even can be doubled.            The nonmetallic fibre optic cable can simply be feeded through a cut of Ø14mm or a tube of Ø16mm into the shielded room... 2-way fibre-optic cable to control one motion device, both ends F-SMA connectors: LWL-2SS-5 Fibre-optic cable, 2-way, length 5 metre LWL-2SS-10 Fibre-optic cable, 2-way, length 10 metre LWL-2SS-20 Fibre-optic cable, 2-way, length 20 metre LWL-2SS-40 Fibre-optic cable, 2-way, length 40 metre LWL-2SS-xx Fibre-optic cable, 2-way, length xx metre (short-term manufacturing according to order) 1-way fibre-optic cable only to control switch-over of the polarization of antenna masts (not RSM 010): LWL-1SS-5 Fibre-optic cable, 1-way, length 5 metre LWL-1SS-10 Fibre-optic cable, 1-way, length 10 metre LWL-1SS-20 Fibre-optic cable, 1-way, length 20 metre LWL-1SS-40 Fibre-optic cable, 1-way, length 40 metre LWL-1SS-xx Fibre-optic cable, 1-way, length xx metre (short-term manufacturing according to order) LWL-FSMA One-piece feed-through adapter to feed control signals through the metal sheet REP 016-2 Repeater for the regeneration of optical signals between controller and motion device if the distance is more than 80 metre; 2-way for one motion device REP 016-4 Repeater for the regeneration of optical signals between controller and motion device if the distance is more than 80 metre; 4-way for two motion devices Exchange of damaged fibre-optic cables with the older round Amphenol plug Description: (141 kB) Conversion sets: RSC-Z2 Fibre-optic conversion set from Amphenol to F-SMA (optic/optic) for one controller channel or one motion device; for exchange at a motion device please term us typ and SN of the motion device to deliver cables with exact length RSC-Z3 Fibre-optic conversion set from Amphenol to F-SMA (optic/electrical) for one controller channel or one motion device; for exchange at a motion device please term us typ and SN of the motion device to deliver cables with exact length